Thursday, May 30, 2024
Home Uncategorized How to use belt packer

How to use belt packer

by admin
0 comment

how to use the belt packer:

1. First, open the drum of the belt packer

2. Put the whole roll of tape into the tape cutter

banner

3. Fix the tape roll with a fixed core

4. Pull out the front part of the whole roll of tape and let the tape pass through the gap between the front axle and the bottom of the tape cutter from the bottom. Note that in order to make the tape slide smoothly, please ensure that the sticky side of the tape is facing down

5. Next, gently pull the small square at the front end of the tape, pull out a section of tape down, and then gently stick it up with the blade and pull it back to cut the tape

the belt packer can also be called the belt sealing machine. It is economical, fast and easy to adjust. It can complete the upper and lower sealing actions at one time
1. First place the sealing machine on the horizontal ground, lock the brake casters, adjust the frame feet to the appropriate height, and make the machine frame seat in the horizontal position
2. Place the carton to be sealed on the conveying table:
A. adjust the lifting handle so that the conveying bottom plane of the upper tape head seat is about 3-5mm lower than the height of the carton
B. loosen the locking hand wheel II, adjust the conveying clamp to make the conveying clamp close to the carton, and then lock the locking hand wheel II
C. adjust the carton positioning wheel so that the carton positioning wheel and the conveying clamp stick are close to the carton at the same time, and then lock the hand wheel I
3. Turn on the power switch to make the machine work, and then push the carton into the carton to seal the carton. If it is found that the upper and lower sealing tapes are not tight enough, adjust the knob of the belt barrel seat (generally, if the tape is too tight, loosen the spring pressure; if the tape is too loose, tighten the spring pressure)
4. If the length of both ends of the sealing tape is different, adjust the cutting blade in the tape head (generally, the head is long and the tail is short, adjust the cutting blade, loosen the locking screw of the cutting blade, move the cutting blade outward a little, and then lock the screw. On the contrary, if the head is short and the tail is long, move the cutting blade inward a little)
faults and solutions are as follows:
1 The nail clamping action of the sealing machine is too slow or the nail clamping stroke is insufficient: the bolt is loose, the front buckle or the inner plate of the board machine is worn. At this time, tighten the bolt and pay attention to the correct position of the front buckle shaft. You can also replace the front buckle or the inner plate of the board machine. After completing the above actions, test its function. If the stroke is too short, fine tune the front buckle shaft upward, and if the action is slow, fine tune the front buckle shaft downward
2. Air leakage at the piston rod: the bottom ring of the main body is damaged. Replace the ring at this time
3. Air leakage at the exhaust port: the on-off valve ring or switch seat ring is damaged or the piston ring is damaged. Replace the ring
4. Air leakage at the trigger: the on-off valve ring or switch seat ring is damaged. Replace the ring
5. The drive ring is loose and cannot be positioned: the plastic steel strip and drive spring are inelastic. Remove the plate machine assembly and reinstall the spring tip or replace the plastic steel strip and transmission spring.

Hello, are you talking about the sealing machine? See personal data

You may also like

Leave a Comment

Soledad is the Best Newspaper and Magazine WordPress Theme with tons of options and demos ready to import. This theme is perfect for blogs and excellent for online stores, news, magazine or review sites.

Buy Soledad now!

Edtior's Picks

Latest Articles

u00a92022u00a0Soledad.u00a0All Right Reserved. Designed and Developed byu00a0Penci Design.